Bathroom Remodeling Articles

Your bathroom can achieve a couple of things when a fresh faucet is installed.  Basically it is not a wise decision to replace the faucets with an old one with tear and wear after all it is used the most in the bathroom.  Moreover it does not take much effort to renews the look of your bathroom a way or two. If you say, you never have done anything of this sort in the past, why not try and learn some plumbing and it is the best place to learn a bit too.

First and foremost, you should ensure you get rid of the old faucet. The hot and cold water valves are there just below the sink.  Make sure you turn it to the extreme right and open the faucet that it is sealed. You can easily remove the connections from the bowels with a pair of pliers. You will need to however get rid of them from the faucet finally but we shall do that at a later stage.

Next, you will need to remove the connection for the terrain stopper if you have one. Under the sink you will see a long, thin post, I attached in some way to another post connected to the drain pipe. While there are different types of screws and clams that will hold the ease two posts together, they are typically pretty simple and just a little bit of fiddling will allow you to disconnect them.

Now you will need to loosen the faucet itself from the sink. This can be the tricky part. Under each of the hot and cold water connections you will find a large net of some kind, typically made of metal or plastic.  While some are designed to be removed by hand, you may very well have to use a pair of pliers to loosen them until you can turn them by hand. Because it is likely to be at a minimum, you’ll have to make do with very small turns.

Once the connections are loose you might find that you need to also remove the hot and cold water connections from the faucet itself. In some cases you will be able to lift the faucet out to the sink with the water supply lines connected, but this is not often the case. We recommend replacing water supply lines each time you replace a faucet, in which case you would need to disconnect the lines from both the valve and the faucet anyway here

Once the faucet has been disconnected from the same, the supply lines, and the plunger you can simply lift it out and throw it away. At this point, all that’s left for you to do is repeat these steps in reverse for the new faucet. Slide the new faucet into place, use the new nuts to secure it to the sink, connect the water supply lines to the faucet, attach the plunger stem to the drain hose, fit the supply lines back onto the valves, and then charge the lines by opening the valves.

Before you close on the work, you need to ensure that there are no leaks in the supply lines. It is not possible to make sure a tight seal with Teflon tape view image but do it to prevent any leaks there. You are now convinced of how easy is plumbing a faucet, aren’t you? All it requires is a bit of patients and know how tools to actually make plumbing your faucet succeed.